StarlettePlus-E Refrigeration Dryers

Refrigerated Air Dryers That Keep Water Out of Your Air Lines

Every compressor makes wet air. As hot, saturated air leaves the compressor and cools in the receiver and piping, it dumps liquid water, rust, and oily condensate straight into your tools, actuators, paint guns, and pneumatic controls. A Parker StarlettePlus-E refrigerated air dryer stops that at the source, pulling moisture out of your compressed air before it ever reaches your equipment.

Built Around the E-Pack Heat Exchanger

• State-of-the-art aluminum E-Pack heat exchanger pre-cools incoming air to cut energy consumption
• Smaller refrigerant charge and lower absorbed power than comparable dryers on the market
• Low pressure-drop, cross-flow design keeps operating costs down over the life of the unit
• High-efficiency stainless steel demister separator removes liquid across all operating conditions
• Environmentally friendly, low-GWP R513A refrigerant on every model
• Digital controller with air temperature readout, service reminder, volt-free alarm contact, and integral timed drain

Sized Right for Garages, Shops, and Industrial Lines

The StarlettePlus-E lineup covers 15 to 125 SCFM, so whether you're running a single-bay garage compressor, a fabrication shop, or a mine site air header, there's a model matched to your flow rate. Undersizing a dryer is the most common reason shops still see water in their lines after "fixing" the problem — match your dryer to your compressor's actual output, not just the tank size.

Specifications at a Glance

• Flow rates: 15, 25, 35, 50, 75, and 125 SCFM
• Operating pressure: 29–232 psig (2–16 barg)
• Inlet air temperature: 41°F–149°F (5°C–65°C)
• Maximum ambient temperature: 122°F (50°C)
• Pressure dew point: approximately 37°F (3°C) at rated conditions
• Electrical supply: 115V / 1-Phase / 60Hz
• Refrigerant: R513A (low Global Warming Potential)
• Connections: 1/2" NPT (15–25 SCFM), 3/4" NPT (35–50 SCFM), 1" NPT (75–125 SCFM)

Pair It With the Right Filtration

A refrigerated dryer works best alongside proper air preparation filters and regulators upstream and downstream — this protects the heat exchanger from oil and particulate while giving you the cleanest, driest air possible at the point of use.

Not sure which CFM size fits your compressor, or need help with installation? Request service from our team and we'll help you get it right the first time.